IEC 61439-2 Simplified
Keeping it simple for IEC 61439-2 compliance!
IEC 61439-2 is the relevant standard for ‘Low-voltage Power Switchgear and Control gear Assemblies’
According to the standard, it is a requirement that all assemblies are Verified (Design & Routine Verification) and supplied with information relating to these verified characteristics (e.g. operational voltage, IP Code etc.)
Elsteel has since the introduction of IEC 61439 in 2009, successfully completed a huge amount of Design Verification by Test, and continues to do so, resulting in a vast reference library of tested reference designs.
When you design your panel with Techno Module system, you can check your proposed design (i.e. compartment size, rated circuit current, circuit-breaker) against our tested reference library. This ensures that you have a valid Design Verification relating to IEC 61439-2.
Typically your design will be ‘bespoke’ and will require you to carry out additional Design Verifications, e.g. for temperature-rise limits. These can generally be done using Design Verification by Comparison or by Assessment and involve reference to tested designs, calculations and applying ‘design rules’ and safety margins as detailed in IEC 61439-2
We can provide design verification reports specified exactly to your project! Contact us for more info!
Typical route to compliance:
New Enquiry
Create design using
Elsteel
Techno Module System
New Design
Verifications
(where required)
Routine Verification
+
Assembly Information
IEC 61439
Compliant Assembly
Elsteel
Reference Library
(Tested Designs)
D.V. by Comparison
D.V. by Assessment
Conformity to
local/national
requirements
Why Elsteel?
Elsteel is a one stop supplier for all low voltage enclosures. From the smallest terminal box to the largest distribution boards and motor control centers!
Being one of the most modern players in the market...
Reduce CO2
Environment friendly panel technology at Elsteel.
Reduction of energy used and CO2 Released into our environment is a big issue for Elsteel when designing sustainable solutions for
News
Charity in 2019
Our major charity project in 2019 was to build a nursery in a rural area in the North Western part of Sri Lanka
Assembly Videos
Check out these assembly clips that show how quick and easy it is to build panel boards with Techno Module!
More